Racelogic VBOX 3iV2 Guide de l'utilisateur télécharger pdf (Page 32)

VBOX 3i User Guide

Page 32 of 46

28/08/2013

Hardware configuration

First the VBOX 3i needs to be configured to use the IMU data from the IMU03 it is connected to.

1. Connect the IMU to the CAN port of the VBOX 3i with the required cable and power the VBOX 3i.

2. Open VBOX Tools and connect the computer to the VBOX 3i using either serial, USB or Bluetooth.

3. Select the appropriate COM port. The „serial data OK‟ message should appear in green beneath the

COM port number.

4. Click on the „VBOX Setup‟ button to open the VBOX setup window.

5. Underneath the “Channels” tab a „3-axis Modules‟ tab should be visible. This indicates the IMU has

been correctly detected by the VBOX 3i.

6. If the „3 axis Modules‟ tab is not visible, click on

the „CAN‟ button at the top of the window.

7. Make sure that the „Racelogic CAN Modules only‟ (red) is assigned to the CAN port that the IMU is

connected to.

8. Exit setup, then re-enter. This should correctly detect the presence of the IMU data should the ports

have previously been swapped.

NB: If the IMU tab has still not appeared under channels, the IMU settings should be checked to

make sure it is transmitting data at the correct baud rate and is configured correctly. If the LED

above the CAN port is not lit green the CAN messages from the IMU are not being understood by

the VBOX 3i and it is likely the IMU configuration is incorrect.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 45 46

Pas de commentaire

Racelogic VBOX 3iV2 Guide de l'utilisateur Page 32