Racelogic USER GUIDE Manuel d'instructions télécharger pdf (Page 10)

Revision 13 Page 10 of 35

LabSat Settings Menu

The LabSat software can be used to control LabSat hardware, as well as the multi-GNSS LabSat 2. When a LabSat is connected to the PC the LabSat

software will auto-detect the type of hardware connected and configure LabSat correctly.

In the example shown, left, a LabSat Record and Replay unit has been

connected to the PC. The LabSat software has been started and the Settings

menus accessed.

LabSat is a single channel GNSS Replay and/or Record Simulator. The

device will record and replay from the GPS L1 RF signal. This is the default

position for LabSat.

In the example shown GNSS Monitor is set to Internal LabSat. This uses the

internal GPS engine to monitor GPS signals during Replay only on the LabSat

software GUI. The monitor can be set to Internal LabSat (10Hz) which will

use up to to eight satellites only in this mode. An external Serial Monitor may

also be selected, to display NMEA data (if available) from the GPS receiver

under test on the LabSat software. The NVS NVO8C setting refers to a GPS

& GLONASS monitor capability for LabSat 2. The GNSS Monitor may also be

disabled to allow for other programmes to monitor the LabSat GPS receiver

output.

Note the Video Sync and Serial Proxy tick boxes. Video Sync allows for the

synchronisation of the LabSat scenario with a video VBOX recording of the

route. Serial Proxy allows for the serial NMEA data from the internal receiver

to be redirected to another port. The Turntable Control is part of the LabSat

Turntable application. Please contact your LabSat distributor or Racelogic for

further details.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 34 35

Pas de commentaire

Racelogic USER GUIDE Manuel d'instructions Page 10