Racelogic USER GUIDE Manuel d'utilisateur télécharger pdf (Page 20)

RACELOGIC Traction Control Manual V3.0

Page 20

Q – The car runs cleanly when stationary but misfires when driving.

A – Does the car only misfire at low speed ?

Yes - Use the diagnostic light or laptop to ensure all the wheel speeds

are being indicated and are picking up at roughly the same speed.

If all of the wheel speeds are not being picked up until higher speeds,

connect each of the wheel speed pickup wires to the other side of the

ABS sensor wires.

If for example two wheel speeds come in early and two come in late

use the table below to find out which wire colours correspond to which

adjuster position and swap those wires.

Q – The car misfires throughout the whole rev-range.

A - Use the diagnostic light to ensure the traction control is picking up all

four wheel speeds and engine revs. If any of the wheel speeds are

missing, the adjuster position relates to each of the following wire

colours.

Adjuster Position Description Traction control Wire Colour

Wet Wheel speed 1 Red

5% Wheel speed 2 Blue

10% Wheel speed 3 Yellow

15% Wheel speed 4 Green

20% RPM White/Black

Off RPM White/Black

If the misfire persists:

A - Reconnect the car to standard with the two 8 way multilok connectors

and see if the misfire clears.

Q – The system is not picking up any wheel speeds.

A – Check the wires are connected to the ABS sensors.

A - Connect each of the wheel speed pickup wires to the other side of the

ABS sensor wires.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 66 67

Pas de commentaire

Racelogic USER GUIDE Manuel d'utilisateur Page 20