Racelogic USER GUIDE Manuel d'utilisateur télécharger pdf (Page 48)

RACELOGIC Traction Control Manual V3.0

Page 48

To reduce power the traction control uses four levels of progressively intrusive

cut. These are sequence 1,2,3 and Integral.

If the traction control is reducing power using sequence 1 and the slip reaches

the value set for sequence 2, then the traction control will start to use

sequence 2 instead of sequence 1.

Note: These same cuts are used for both wet and dry settings.

Default value: Sequence1 5%, Sequence2 10%, Sequence3 15%

Integral settings

Placing a

will allow an injector to fire, putting a will prevent the injector

from firing.

Integral setting effect all of the cylinders even if the unit is set up for non-

sequential mode.

Start After

If the wheels continue to slip despite the activation of sequence 3 cut then

after a period of time defined by the ‘Start after’ value then the integral cut is

applied.

Default value: 0.04 Seconds

3.4 Wheels

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 66 67

Pas de commentaire

Racelogic USER GUIDE Manuel d'utilisateur Page 48